Hardware Specifications |
Copper Ports |
5 10/100/1000BASE-T RJ45 auto-MDI/MDI-X ports |
SFP/mini-GBIC Slots |
2 1000BASE-SX/LX/BX SFP interfaces (Port-6 to Port-7)
Compatible with 100BASE-FX SFP |
PoE Injector Port |
4 ports with Ultra PoE/802.3at/af PoE injector function with Port-1
to Port-4 |
Console |
1 x RJ45-to-RS232 serial port (115200, 8, N, 1) |
Switch Architecture |
Store-and-Forward |
Switch Fabric |
14Gbps/non-blocking |
Throughput (packet per
second) |
10.42Mpps@ 64 bytes packet |
Address Table |
8K entries, automatic source address learning and aging |
Shared Data Buffer |
4Mbits |
Flow Control |
IEEE 802.3x pause frame for full-duplex
Back pressure for half-duplex |
Jumbo Frame |
9Kbytes |
Reset Button |
< 5 sec: System reboot
> 5 sec: Factory default |
ESD Protection |
6KV DC |
Enclosure |
IP30 aluminum case |
Installation |
DIN rail kit and wall-mount kit |
Connector |
Removable 6-pin terminal block for power input
Pin 1/2 for Power 1, Pin 3/4 for fault alarm, Pin 5/6 for Power 2
Removable 6-pin terminal block for DI/DO interface
Pin 1/2 for DI 1 & 2, Pin 3/4 for DO 1 & 2, Pin 5/6 for GND |
Alarm |
One relay output for power failure. Alarm relay current carry
ability: 1A @ 24V DC |
DI/DO |
2 Digital Input (DI):
Level 0: -24V~2.1V (¡Ó0.1V)
Level 1: 2.1V~24V (¡Ó0.1V)
Input load to 24V DC, 10mA max.
2 Digital Output (DO):
Open collector to 24V DC, 100mA max. |
LED Indicator |
System:
Power 1 (Green)
Power 2 (Green)
Fault Alarm ( Red )
Ring (Green)
Ring Owner (Green)
DIDO ( Red )
Per 10/100/1000T RJ45 Ports:
100 LNK/ACT (Orange)
1000 LNK/ACT (Green)
Per SFP Interface:
100 LNK/ACT (Orange)
1000 LNK/ACT (Green)
Per PoE Port:
Ultra 60W PoE-in-use x 1 (Green)
802.3at/af PoE-in-use x1 (Orange)
PoE Usage:
60W, 120W, 180W, 240W (Green) |
Dimensions (W x D x H) |
72 x 107 x 152 mm |
Weight |
1050g |
Power Requirements |
Dual 48~56V DC (>52V DC for PoE+ output recommended) |
Power Consumption |
Max. 6.6 watts/22.52BTU (Power on without any connection)
Max. 282 watts/962.22BTU (Full loading with Ultra PoE function) |
Power Over Ethernet |
PoE Standard |
IEEE 802.3af/802.3at/Ultra PoE PSE |
PoE Power Supply Type |
End-span/Mid-span/UPoE |
PoE Power Output |
IEEE 802.3af Standard
- Per port 48V~52V DC (depending on the power supply), max. 15.4 watts
IEEE 802.3at Standard
- Per port 52V~56V DC (depending on the power supply), max. 36 watts
Ultra PoE
- Per port 48V~56V DC (depending on the power supply), max. 72 watts |
Power Pin Assignment |
End-span: 1/2(-), 3/6(+)
Mid-span: 4/5(+), 7/8(-)
UPoE: 1/2(-), 3/6(+),4/5(+), 7/8(-) |
PoE Power Budget |
240W maximum (depending on power input) |
PoE Ability PD @ 15 watts |
4 units |
PoE Ability PD @ 30 watts |
4 units |
PoE Ability PD @ 60 watts |
4 units |
Layer 2 Function |
Basic Management Interfaces |
Console; Telnet; Web browser; SNMP v1, v2c |
Secure Management Interfaces |
SSH, SSL, SNMP v3 |
Port Configuration |
Port disable/enable
Auto-negotiation 10/100/1000Mbps full and half duplex mode selection
Flow control disable/enable |
Port Status |
Display each port¡¦s speed duplex mode, link status, flow control
status,
auto negotiation status, trunk status |
Port Mirroring |
TX/RX/both
1 to 1 monitor |
VLAN |
802.1Q tagged based VLAN, up to 255 VLAN groups
Q-in-Q tunneling
Private VLAN Edge (PVE)
MAC-based VLAN
Protocol-based VLAN
Voice VLAN
MVR (Multicast VLAN Registration)
Up to 255 VLAN groups, out of 4095 VLAN IDs |
Link Aggregation |
IEEE 802.3ad LACP/static trunk
Supports 3 trunk groups with 3 ports per trunk group |
QoS |
Traffic classification based, strict priority and WRR
8-level priority for switching
- Port number
- 802.1p priority
- 802.1Q VLAN tag
- DSCP/TOS field in IP packet |
IGMP Snooping |
IGMP (v1/v2/v3) snooping, up to 255 multicast groups
IGMP querier mode support |
MLD Snooping |
MLD (v1/v2) snooping, up to 255 multicast groups
MLD querier mode support |
Access Control List |
IP-based ACL/MAC-based ACL
Up to 123 entries |
Bandwidth Control |
Per port bandwidth control
Ingress: 500Kb~1000Mbps
Egress: 500Kb~1000Mbps |
SNMP MIBs |
RFC 1213 MIB-II
RFC 1493 Bridge MIB
RFC 1643 Ethernet MIB
RFC 2863 Interface MIB
RFC 2665 Ether-Like MIB
RFC 2819 RMON MIB (Groups 1, 2, 3 and 9)
RFC 2737 Entity MIB
RFC 2618 RADIUS Client MIB
RFC 2933 IGMP-STD-MIB
RFC 3411 SNMP-Frameworks-MIB
IEEE 802.1X PAE
LLDP
MAU-MIB |
Layer 3 Function |
IP Interfaces |
Max. 8 VLAN interfaces |
Routing Table |
Max. 32 routing entries |
Routing Protocols |
IPv4 software static routing
IPv6 software static routing |
Standards Conformance |
Regulatory Compliance |
FCC Part 15 Class A, CE |
Stability Testing |
IEC60068-2-32 (free fall)
IEC60068-2-27 (shock)
IEC60068-2-6 (vibration) |
Standards Compliance |
IEEE 802.3 10BASE-T
IEEE 802.3u 100BASE-TX/100BASE-FX
IEEE 802.3z Gigabit SX/LX
IEEE 802.3ab Gigabit 1000T
IEEE 802.3x flow control and back pressure
IEEE 802.3ad port trunk with LACP
IEEE 802.1D Spanning Tree Protocol
IEEE 802.1w Rapid Spanning Tree Protocol
IEEE 802.1s Multiple Spanning Tree Protocol
IEEE 802.1p Class of Service
IEEE 802.1Q VLAN tagging
IEEE 802.1X Port Authentication Network Control
IEEE 802.1ab LLDP
IEEE 802.3af Power over Ethernet
IEEE 802.3at Power over Ethernet Plus
IEEE 802.3bt Power over Ethernet ready
RFC 768 UDP
RFC 793 TFTP
RFC 791 IP
RFC 792 ICMP
RFC 2068 HTTP
RFC 1112 IGMP v1
RFC 2236 IGMP v2 |
Environment |
Operating Temperature |
-40 ~ 75 degrees C |
Storage Temperature |
-40 ~ 85 degrees C |
Humidity |
5 ~ 95% (non-condensing) |
Ordering Information |
IGS-5225-4UP1T2S |
Industrial L2+ 4-Port 10/100/1000T Ultra PoE + 1-Port 10/100/1000T +
2-Port 100/1000X SFP Managed Switch |