General Specifications
¡P
The
LPe16202-X CFA is powered by the Emulex XE201 converged fabric controller which
is capable of running FC and Ethernet and consists of an eight-lane (x8) PCIe
3.0 bus (backward compatibility to PCIe 2.0 supported)
Architecture
¡P
Supports
up to two FC ports at 16GFC or 8GFC, or two 10GbE FCoE ports
¡P
Dual-port 16GFC optics supports 16GFC, 8GFC and 4GFC link speeds, automatically
negotiated(optics purchased separately)
¡P
Dual-port 8GFC optics* supports 8GFC, 4GFC and 2GFC link speeds, automatically
negotiated (optics purchased separately)
Ethernet/NIC Feature Support (driver support
varies by Operating System)
¡P
Jumbo
frames support for frame sizes of at least 9 Kbytes
¡P
Hardware
TCP/UDP checksum generation
¡P
Hardware
IPv4/IPv6 checksum offload
¡P
Hardware
Large Segmentation Offload
¡P
Hardware
Header and Data Split
¡P
Full
duplex operation is supported
¡P
Up to
128 MAC addresses
¡P
Unicast/Multi-cast
address filtering
¡P
VMware
Netqueue
¡P
Packet
Filtering based on MAC address or VLAN tag
¡P
Microsoft Receive Side Scaling (RSS)
¡P
NIC
Teaming (NOTE: Enabled via host-side drivers)
¡P
PCI
hotplug
¡P
PXE Boot
¡P
FCode
¡P
Priority
Flow Control 802.1Qbb Ver 0
¡P
DCB
Exchange Protocol (DCBX) Ver 1.01
¡P
Enhanced
Transmission Selection 802.1Qaz Ver 0
¡P
T11 FCoE
Initialization Prototcol (FIP) Rev.2.0, T11/09-056v5
Fibre Channel / Fibre Channel over Ethernet
Standards
¡P
Topologies supported include FC-SW switched fabric (N_Port), Point-to-point (N_Port)
and FC-AL Arbitrated Loop (NL_Port)¡Xon 2GFC/4GFC/8GFC speeds
¡P
Dual
port FC Over Ethernet
¡P
FC &
FCoE Compatible with:
¡P
Fibre
Channel Physical and Signaling (FC-PH, FC-PH2, FC-PH3)
¡P
Fibre
Channel Arbitrated Loop (FC-AL-2)¡X on 2GFC/4GFC/8GFC speeds
¡P
Fibre
Channel Generic Services (FC-GS-3)
¡P
Fibre
Channel Framing and Signaling (FC-FS)
¡P
Fibre
Channel Physical Interface (FC-PI)
¡P
Fibre
Channel Tape and Medium Changers (FC-Tape)
¡P
Fibre
Channel Switch Fabric (FC-SW-4)
¡P
Fibre
Channel Protocol for SCSI Support (FC-FCP, FC-FCP2, FCP-3-SCSI)
¡P
FMA
support
¡P
T10 DIF
or T10 PI native support
¡P
Fibre
Channel interface compliant with appropriate T11.org specifications
¡P
Fibre
Channel General Services (FC-GS, FC-GS-2, FC-GS-3)
PCI Specifications
¡P
PCI
Express Base Specification 3.0
¡P
PCI
Express Card Electromechanical Specification (CEM) 2.0
¡P
PCI
ExpressModule Electromechanical Specification 1.0
¡P
BIOS
Boot Specification Version 1.01 (Compaq Computer, Phoenix Technologies, Intel)
¡P
IEEE Std
1275-1994 IEEE Standard for Boot (Initialization Configuration) Firmware: Core
Requirements and Practices (OpenBoot standard)
¡P
PCI
Express Base Specification Rev. 2.1
¡P
PCI
Express Card Electromechanical Specification Rev. 2.0
¡P
PCI
Local Bus Specification Rev. 3.0
¡P
PCI Bus
Power Management Interface Specification Rev. 1.2
¡P
PCI
Hot-Plug Specification Rev. 1.1
¡P
PCI-to-PCI Bridge Architecture Specification Rev. 1.2
¡P
PCI
Express to PCI/PCIX Bridge Specification Rev 1.0
¡P
PCI-SIG
Single Root I/O Virtualization and Sharing Specification Rev. 1.1
¡P
SFF
8431- SFP+ PCIe Specifications
Data Integrity
¡P
Supports
T10 PI / Data Integrity Field (T10 DIF) standard per T10 working group with high
performance offload
¡P
Simultaneous 512-Byte and 520-Byte block support
¡P
Simultaneous 4096-Byte and 4104-Byte block support
¡P
DIF
Error Reporting
¡P
End-to-End CRC (ECRC) support per PCIe 3.0 specification
¡P
GMAC
support
Ethernet and NIC Standards
¡P
IEEE
802.1Q VLAN
¡P
IEEE
802.1P and 802.1D
¡P
IEEE
802.3x
¡P
IEEE
802.1Qbb
¡P
IEEE
802.1Qaz
¡P
IEEE
802.3ab/802.3z
¡P
DCBX
Comprehensive OS and Hypervisor Support
¡P
Windows
Server
¡P
Linux
¡P
Solaris
¡P
VMware
vSphere
¡P
Windows
Hyper-V
¡P
Additional support is available from OEMs and partners
Hardware Environments
¡P
SPARC
and x86/64
Optical
¡P
Fibre
Channel data rates: 14.025 Gb/s (1600Mb/s); 8.5 Gb/s (800Mb/s); 4.25 Gb/s (400
Mb/s) (auto-detected)
¡P
Ethernet
data rates: 10.3125 Gb/s, full-duplex line rate
¡P
Optics:
Short wave lasers with LC type connector
¡P
Cable:
Operating at 16Gb
¡P
15m at
16Gb on 62.5/125 £gm OM1 Multi-Mode Fibre (MMF)
¡P
35m at
16Gb on 50/125 £gm OM2 MMF
¡P
100m at
16Gb on 50/125 £gm OM3 MMF
¡P
125m at
16Gb on 50/125 £gm OM4 MMF
¡P
Cable:
Operating at 10GbE (for 850 nm wavelength multi-mode cables; 1300 nm wavelength
cables can support longer distances)
¡P
33m at
10Gb on 62.5/125 £gm OM1 MMF
¡P
82m at
10Gb on 50/125 £gm OM2 MMF
¡P
up to
300m at 10Gb on 50/125 £gm OM3 MMF
¡P
up to
400m at 10Gb on 50/125 £gm OM4 MMF
Physical Dimensions
¡P
Short,
low profile MD2 form factor card
¡P
167.64mm
x 68.91mm (6.60¡¨ x 2.71¡¨)
¡P
Low
profile bracket
¡P
Standard
bracket ships in the box
Power & Environmental Requirements
Power supply 1.8V, 1.2V, 0.9V
¡P
Volts:
+3.3, +12
¡P
Operating temperature: 0¢X to 58¢X C (32¢X to 131¢X F)
¡P
Storage
temperature: -43¢X to 73¢X C (-40¢X to 158¢X F)
¡P
Humidity:
¡P
Operating: 10 percent to 90 percent RH, non-condensing, 27¢XC max wet bulb
¡P
Non-operating: 93 percent RH, non-condensing, 38¢XC max wet bulb
Altitude
¡P
Operating: 3000m, Non-operating: 12,000m
Vibration
¡P
Operating: 0.20G in all axes, 5-500 Hz sine
¡P
Non-operating: 1.0G in all axes, 5-500 Hz sine
Shock
¡P
Operating: 5G, 11 ms half-sine
¡P
Non-operating: 30G 11 ms half-sine\
Boot Support
¡P
x86
(Solaris, RHEL, SLES, OEL, Oracle VM, ESX/ESXi, Windows Server)
¡P
FC Boot
¡P
PXE Boot
¡P
iBFT
Software iSCSI Boot
¡P
FCoE
Boot UEFI (for Intel E5 2600 based servers)
¡P
FC Boot
¡P
NIC PXE
Boot
¡P
iBFT SW
iSCSI Boot
¡P
FCoE
Boot Solaris SparcFC FCode
¡P
NIC
FCode
¡P
iSCSI
not required (built into OBP)
¡P
FCoE
FCode
Class 1 Laser Product per DHHS 21CFR (J) and EN60825-1*
¡P
UL
recognized to UL 60950-1 2nd edition
¡P
cUR
recognized to CSA22.2, No. 60950-1-07
¡P
TUV
Bauart-certified to EN60950-1:2006 +A11+A1+A12
¡P
FCC Part
15, Class A
¡P
ICES-003:2012, Class A
¡P
EMC
Directive 2004/108/EC (CE Mark)
¡P
EN55022:2010, Class A
¡P
EN55024:2010
¡P
Australian EMC Framework (C-Tick Mark)
¡P
AS/NZS
CISPR:2009 +A1, Class A
¡P
VCCI
Class A
¡P
BSMI
Class A
¡P
CNS13438:2006 (complete)
¡P
MSIP
(formally KCC/MIC), Class A
¡P
EU RoHS
Compliant (Directive 2011/65/EU)
¡P
China
RoHS Compliant
Added Features
Performance Features
¡P
Doubling
the maximum FC link rate from 8GFC to 16GFC and enhanced virtualization
capabilities, helps support IT ¡§green¡¨ initiatives.
¡P
Frame-level multiplexing and out-of-order frame reassembly increases link
efficiency and maximizes HBA performance. Data Protection Features
¡P
End-to-end data protection with hardware parity, CRC, ECC and other advanced
error checking and correcting algorithms ensure data is safe from corruption.
¡P
Enhanced
silent data corruption protection provided by T10 PI with high performance
offload.
Deployment and Management Features
¡P
Universal boot capability allows the appropriate boot environment to be
automatically selected for any given hardware.
¡P
Boot
from SAN capability reduces system management costs and increases uptime.
¡P
Detailed, real-time event logging and tracing enables quick diagnosis of SAN
problems.
¡P
Beaconing feature flashes the HBA LEDs, simplifying their identification within
server racks.
¡P
Environmental monitoring feature helps optimize SAN availability.
Management Features
¡P
The
Emulex OneCommand Manager application enables centralized discovery, monitoring,
reporting, and administration of adapters provided by Emulex on local and remote
hosts. Powerful automation capabilities facilitate remote driver parameter,
firmware and boot code upgrades.
¡P
Advanced
diagnostic features, such as adapter port beaconing and adapter statistics, help
optimize management and network performance, while the environmental monitoring
feature helps to maintain optimum host-to-fabric connections. In addition to the
GUI interface, management functions can also be performed via a scriptable
Command Line Interface (CLI) as well as a web browser.
¡P
OneCommand Manager supports role-based management to facilitate administration
of adapters throughout the data center without compromising security. Management
privileges can be assigned based on LDAP and AD group memberships.
¡P
Emulex¡¦s
management instrumentation complies to open management standards, such as SMI-S
and common HBA API support, which enables seamless upward integration into
enterprise storage and server management solutions.
¡P
Driver
and devices fully integrated and operating with Oracle Solaris management (FMA,
DTrace) as well as Oracle VM for SPARC and Oracle VM for x86